| 1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION |
PRODUCT NAME: ACCL–54T CONNECTOR LUBRICANT
Chemical Name: Petroleum Hydrocarbon/Polyphenyl Ether
Product Description: Near colorless liquid
SantoLubes LLC, 8 Governor Drive, St. Charles, MO 63301
FOR CHEMICAL EMERGENCY, Call CHEMTREC - Day or Night - 800-424-9300. .
| 2. COMPOSITION/INFORMATION ON INGREDIENTS |
Note: ACCL–54T Connector Lubricant is a proprietary blend manufactured by Santovac Fluids LLC. All components appear on the Inventory of Chemical Substances published by the U.S. Environmental Protection Agency (EPA) under the authority of the Toxic Substances Control Act. (TSCA).
| 3. HAZARDS IDENTIFICATION |
This product is hazardous as defined in CFR 1910.1200.
osha hazard
combustible
potential health effects
EYE CONTACT:
Slightly irritating but does not injure eye tissue.
SKIN CONTACT:
May cause moderate irritation with prolonged or repeated contact.
Low order of toxicity
Skin contact may aggravate an existing dermatitis condition.
INHALATION:
High vapor/aerosol concentrations (greater than approximately 1000 ppm) are irritating to the eyes and the respiratory tract, may cause headaches, dizziness, anesthesia, drowsiness, unconsciousness, and other central nervous system effects, including death.
INGESTION:
Small amounts of this product aspirated into the respiratory system during ingestion or vomiting may cause mild to sever pulmonary injury, possibly progressing to death. Minimal toxicity.
| 4. FIRST AID MEASURES |
EYE CONTACT:
Flush eyes with water for a least fifteen minutes and until irritation subsides. If irritation persists, get medical attention.
SKIN CONTACT:
Flush with large amounts of water; use soap if available.
Remove grossly contaminated clothing, including shoes, and launder before reuse.
INHALATION:
Using proper respiratory protection, immediately remove the affected victim from exposure. Administer artificial respiration if breathing is stopped. Keep at rest. Call for prompt medical attention.
INGESTION:
If swallowed, DO NOT induce vomiting. Do not give liquids. Keep at rest. Small amounts that accidentally enter mouth should be rinsed out until taste is gone. Get prompt medical attention.
| 5. FIRE FIGHTING MEASURES |
Flash Point: 142°F Method; TCC NOTE: Minimum
flammable limits: LEL: 1.0 UEL: 8 NOTE: Approximate
Auto ignition Temperature: 572°F NOTE: Approximate
general: "Empty" containers retain product residue (liquid and/or vapor) and can be dangerous. do not pressurize, cut, weld, solder, drill, grind, or expose such containers to heat, flame, sparks, static electricity or other sources of ignition; they may explode and cause injury of death. Empty drums should be completely drained, properly bunged and promptly returned to a drum reconditioner, or properly disposed of properly.
| 6. ACCIDENTAL RELEASE MEASURES |
land spill
Eliminate sources of ignition. Prevent additional discharge of material, if possible to do so without hazard. For small spills implement cleanup procedures; for large spills, implement cleanup procedures and, if in public area, keep public away and advise authorities. Also, if this product is subject to CERCLA reporting (see Section 15 REGULATORY INFORMATION) notify the National Response Center. Prevent liquid from entering sewers, watercourses, or low areas. Contain spilled liquid with sand or earth. Do not use combustible materials such as sawdust. Recover by pumping (use an explosion-proof or hand pump) or with a suitable absorbent. Consult an expert on disposal of recovered material and ensure conformity to local disposal regulations.
water spill
Eliminate sources of ignition. Warn occupants and shipping in surrounding and downwind areas of fire and explosion hazards and request all to stay clear. Remove from surface by skimming or with suitable absorbents. If allowed by local authorities and environmental agencies, sinking and/or suitable dispersants may be used in non-confined water. Consult an expert on disposal of recovered material and ensure conformity to local disposal regulations.
| 7. HANDLING AND STORAGE |
electrostatic accumulation hazard:
Yes, Use proper grounding procedure
storage temperature, °F: Ambient
storage/transport pressure, mm. Hg.: Atmospheric
storage and handling:
Keep container closed. Handle and open containers with care. Store in a cool, well-ventilated place away from incompatible materials. Do NOT handle or store near an open flame, heat or other sources of ignition. Protect material from direct sunlight. Material will accumulate static charges, which may cause an electrical spark (ignition source). Use proper grounding procedures.
DO NOT pressurize, cut, heat, or weld containers. Empty product containers may contain product residue. DO NOT reuse empty containers without commercial cleaning or reconditioning.
| 8. EXPOSURE CONTROLS/PERSONAL PROTECTION |
exposure controls
The use of mechanical dilution ventilation is recommended whenever this product is used in a confined space, is heated above ambient temperatures, or is agitated.
personal protection
For open systems where contact is likely, wear safety glasses with side shields, long sleeves, and chemical resistant gloves. Where contact may occur, wear safety glasses with side shields.
Where concentrations in air may exceed the limits given in this section and engineering, work practice or other means of exposure reduction are not adequate, NIOSH/MSHA approved respirators may be necessary to prevent overexposure by inhalation.
recommended occupational exposure limit
100 ppm total hydrocarbon
| 9. PHYSICAL AND CHEMICAL PROPERTIES |
specific gravity: 0.75 – 0.80°C
vapor pressure: < 0.1 mm. Hg. @ 41°C (approximate)
solubility in water: Nil
Viscosity of liquid: N/A
specific gravity (vapor): 6.9 (air = 1)
freezing/melting point: N/A
evaporation rate: 0.01 (n–Bu Accetate = 1)
boiling point: 355°F (approximate)
| 10. STABILITY AND REACTIVITY |
stability: Stable
conditions to avoid: Not Applicable
hazardous polymerization: Will not occur
conditions to avoid hazardous polymerization: Not Applicable
Materials to avoid incompatibility: Strong Oxidizing Agents
hazardous decomposition products: Combustion my produce carbon monoxide and other asphyxiants.
| 11. STABILITY AND REACTIVITY |
No data
| 12. ECOLOGICAL INFORMATION |
No data
| 13. DISPOSAL CONSIDERATIONS |
Dispose of in accordance with all federal, state and local environmental regulations. Recommended method of disposal is by high temperature incineration at a RCRA approved TSDF. If there are any questions regarding the disposal of this material, please consult the Environmental, Health & Safety Department of Santovac Fluids LLC at 636-946-2355. Please refer to sections 5, 6 and 15.
| 14. TRANSPORT INFORMATION |
department of transportation (dot):
Dot Shipping Description:
Petroleum distillate, n.o.s., 3, combustible liquid, un1268, iii
| 15. REGULATORY INFORMATION |
sara title iii:
Under the provisions of Title III, Sections 311/312 of the Superfund Amendments and Reauthorization Act, This product is classified into the following hazard categories:
Immediate (acute) Health Effects YES
Delayed (chronic) Health Effects NO
Fire Hazard YES
Sudden Release of Pressure Hazard NO
Reactivity Hazard NO
This information may be subject to the provisions of the Community Right–To–Know Reporting Requirements (40 CFR 370) if threshold quantity criteria are met.
| 16. OTHER INFORMATION |
This is for people trained in:
National Paint & Coatings Association's (NPCA) Hazardous Materials Identification System (HMIS)
National Fire Protection Association (NFPA 704):
| npca-hmis | nfpa 704 | key | |
| health | 1 | 1 | 4 = Severe |
| flammability | 2 | 2 | 3 = Serious |
| reactivity | 0 | 0 | 2 = Moderate |
| 1 = Slight | |||
| 0 = Minimal |
NOTICE: Although the information and recommendations set forth herein (hereinafter "Information") are presented in good faith and believed to be correct as of the date hereof, SantoLubes LLC makes no representations as to the completeness or accuracy thereof. Information is supplied upon the conditions that the persons receiving same will make their own determinations as to its suitability for their purposes prior to use. In no event will SantoLubes LLC be responsible for damages of any nature whatsoever resulting from the use of or reliance upon information. NO REPRESENTATIONS OR WARRANTIES, EITHER EXPRESSED OR IMPLIED, OR MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE OR OF ANY OTHER NATURE ARE MADE HEREUNDER WITH RESPECT TO INFORMATION OR THE PRODUCT TO WHICH INFORMATION REFERS.
Date: 10/14/05 Supersedes: 10/18/04